13 October 2026

Panamax vs Capesize: how to tell them apart from overhead imagery

Several bulk carriers anchored offshore at twilight, seen in silhouette from the shoreline.

You've got a pass over an anchorage, six bulkers sitting there, and an AIS feed that's gone quiet on three of them. Names unreadable, no port call confirmed, and the broker on the other line wants to know if that's your Capesize or somebody else's Panamax. This happens more than anyone admits, especially off West Africa or in the Red Sea approaches where spoofing and dark periods are routine. The imagery is the only thing you've got left to work with.

Hull proportions tell you more than hull length alone

The fastest tell is beam, not length. Panamax tonnage is still built to the old lock constraint, roughly 32.2 m beam, even though the New Panamax locks opened over a decade ago. A lot of the Panamax fleet trading today was built before that widening and never needed to change. Capesize beam runs wider, typically 43-45 m, because there's no canal to squeeze through.

On an overhead pass at 0.5 m GSD that beam difference shows up as a ratio, not a measurement you'd stake a fixture on. Lay the hull length against the beam: a Panamax reads long and narrow, somewhere around 225 m by 32 m. A Capesize reads shorter relative to its width, often 290-300 m by over 40 m. The silhouette looks stockier even though the vessel is bigger overall.

Length by itself is a weaker signal. Some Kamsarmaxes stretch close to 230 m and get mistaken for small Capesize at a glance. Beam ratio catches that mistake; length alone doesn't.

Deck gear and hatch count narrow it down fast

Most Capesize bulkers are gearless. They load and discharge at terminals built for them, so there's no need for onboard cranes, and the deck reads clean from above aside from hatch covers. Panamax vessels more often carry their own cranes, because a chunk of Panamax trade calls at ports without shoreside loading gear. If you can make out crane silhouettes along the deck centerline, that's leaning Panamax or smaller. A clean deck with just hatch coamings and no visible gear leans Capesize, though plenty of modern Panamaxes have dropped gear too, so treat this as a secondary cue, not a ruling one.

Hatch count also helps. Capesize hulls commonly carry nine hatches given their length, Panamax more often seven. Counting hatch lines across the deck in a sharp overhead image is usually easier than eyeballing beam, especially at marginal resolution or when atmospheric haze softens the contrast between hull and water.

Where loading state comes into the picture

None of this tells you what's in the holds, and that's usually the actual question on the desk. A Capesize sitting high with a wide freeboard band showing above the waterline is running in ballast, whatever the class ID says. The same hull riding low with the waterline close to the main deck is laden or close to it. Size class and loading state are two separate reads off the same image, and traders tend to conflate them because they're looking at the same picture at the same time.

That's the piece behind the weekly loading-state flag: reading freeboard and waterline position off a directly-overhead pass to flag laden, part-laden, or ballast state without waiting on a port call report or trusting a draft survey that's three days stale. It's a weekly read, not continuous tracking, and it's early access rather than a finished product, because optical draft reading still needs proving out across hull types and sea states. The size-class identification above gets you to the right vessel. The freeboard read tells you what it's carrying.

If your anchorage puzzle keeps coming back to "which hull is which and is it loaded," that combination is worth putting on the waitlist.

← Back to the blog